Blog

Some machines have limited space for laser tube mounts. To put in a large diameter laser tube, it is ok to raise one mount higher so the laser beam can hit the first mirror. Just be careful about ai …

read more

Sometimes crashes happen, we need to realign the work table. BTW, We carry DIY kit to build a motorized z table. To make discussion simple, we assume the laser beam go straight down the center of the …

read more

There are three popular types of limit switch on laser machines. Mechanical contact and magnetic types have two pieces of wire. Proximity type needs power, so it has three pieces of wire.Different las …

read more

Unlike acrylic, wood is not a very uniform material. Even when we buy wood from the same manufacturer, every batch may need different power/speed to cut through. MDF has different densities, the de …

read more

For cutting acrylic, the air pressure does not need to be high. It only need to be high enough to prevent fire. One way to prevent fire at the bottom is to put a piece of wet material like paper towel …

read more

When dirty things are stuck inside the water pump, water flow rate will be low and laser tube can get damaged.The following steps apply to many chillers, not just Lightobejct chillers. Please check th …

read more