100W~180W PWM CO2 Laser Power Supply

100 - 180 Power supply. LightObject is excellent to work with. If you have a problem and are not sure of what to buy, call them. They won't recommend the most expensive item; they will suggest the RIGHT item to take care of the problem. I have purchased from them over the years and have never been sorry.12/23/2020

I bought this to replace a failing stock Boss PS. The stock unit that comes with the machine was a 80W-100W supply. This meant that it need to operate at the max to perform well with my 100W tube. This replacement only needs to perform at the minimum to operate well. Of course I had to readjust my cutting and engraving settings but, that only took about thirty minutes . I've had it for a few months now and it's performance is excellent!!! Faster cutting at a lower power is always better. I'll be coming back to LightObject when the time comes for a new tube. Check those dimension before ordering. This is a larger unit than the one it replaced and was a bit of a squeeze to install but it worked out fine.8/18/2020

I bought this to upgrade the stock PS in my 1300x900 130W unit. The machine has been quirky (at best) since I got it. I've upgraded almost every part now with LO parts. Each upgrade provides better performance and more reliable operation. When I received the new PS it would not power on. No fans spinning, nothing. Looking through the vents I could see that the control modules were out of the sockets. With permission from LO I took the cover off and re-seated the boards. I added some silicone to keep them in place and replaced the cover. It has worked perfectly since. The range of power for my 130W tube is much larger now. The stock supply would not fire the tube at under 13%. Now I've gone as low as 7%. Far more useful for intricate cuts. Highly recommended. This upgrade was worth the price. LO support has been terrific also, both by chat and on the phone. 5/10/2019